Gold Medal Mighty-Mite 2035BG, Инструкция по эксплуатации

Страница: 4 / 17

Mighty–Mite
A
LL
M
ODELS
#2035
2
After installation all gas connections must be checked for leaks with a soap solution. When gas
connection is complete, wire the unit to the power source which will carry the current specified on
the unit's data plate.
TYPES OF GAS
The nameplate is marked at the factory to indicate the type of gas the appliance uses: either,
LP or propane for Liquified Petroleum Gas, or NAT or NG for Natural Gas. If necessary the
unit can be altered to change fuels, but we suggest a qualified service person do the work.
Please have your service person refer to the Maintenance and Repair section of this manual.
ALTITUDE RANGE
The factory has sized the burner orifices for an elevation up to 2000 feet above sea level. For
high altitude operation, please contact Gold Medal Engineering for the proper orifice size.
GAS PRESSURE
We have determined that optimum popping results occur when the gas pressure is adequate.
For LP gas, we recommend a pressure setting of 10 inches water column (6 oz. per square
inch); and, for Natural Gas, 4 inches water column (2 oz. per square inch). The pressure is
measured at the appliance while the main burner is ignited. A pressure regulator is supplied to
deliver the optimum pressure for both types of gas when the unit is changed from the original
factory specification. Follow the instructions in the Maintenance and Repair section. Adequate
gas requirements are maintained by properly sized piping. Be sure the piping is properly sized
to supply the needed pressure.
Do NOT use a match or flame to check for leaks – you may
cause a fire or explosion!
a