Gold Medal Econo-Floss, Инструкция по эксплуатации

Страница: 4 / 18

Floss Machines
All Models #3017, #3017SS, and #3077 3
INTRODUCTION
Your Floss Machine warranty is described on the back page of this manual. This does NOT cover the
ribbons, bands or motor bearings since, they can be damaged by the operator.
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be
filed immediately with the transportation company. The warranty also does not cover damage that occurs in
transit or damage caused by abuse or consequential damage due to the operation of this machine, since it
is beyond our control.
ELECTRICAL REQUIREMENTS
The GOLD MEDAL Floss machine requires a 15 amp, 120 volt, 60 cycle electrical
service.
The power supply cord is equipped with a machine ground (the tubular prong on the
male plug). For safety, always plug the machine into a grounded receptacle, which
has been tested for proper polarity to insure electrical safety.
BEFORE PLUGGING IN THE MACHINE
Remove all padding and restraints.
Lower the shipping bracket so the bell housing "floats" freely on the springs. Unscrew and push down the
two knobs on each side of the cabinet top to lower the shipping bracket completely.
Make sure the floss ribbon(s) (heating element) located inside the head assembly has not shaken out of the
band during transportation. If the ribbon is out of the band, push it back into place manually, before plugging
in machine.
CONTROLS AND FUNCTIONS
MAIN SWITCH
-
Turns motor "on" or "off" and supplies current to the heat switch.
HEAT SWITCH
- Turns current to the heating element (ribbon) "on" or "off."
HEAT CONTROL
-
Increases or decreases voltage to ribbon wire heating element using a graduated dial.