Karmel King
Model No. 2620D, 2621D, 2630D, 2631D
Digital
2620DT, 2621DT, 2630DT, 2631DT
Page 6
gmpopcorn.com
Electrical Requirements
The following power supply must be provided (reference unit Data Plate for Wattage requirement):
2620D, 2620DT, 2621D, 2621DT:
240 V~, 60 Hz
2 wire plus ground, single phase. The machine is rated for 28.2 amps. A wall receptacle is
supplied with the machine. This receptacle will accept the attachment plug on the
machine and must be used.
2630D, 2630DT, 2631D, 2631DT:
208 V~, 60 Hz
2 wire plus ground, single phase. The machine is rated for 31.7 amps. A wall receptacle is
supplied with the machine. This receptacle will accept the attachment plug on the
machine and must be used.
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle. Keep cord and plug off the ground and away
from moisture. Always unplug the equipment before cleaning or servicing.
DO NOT immerse any part of this equipment in water.
DO NOT use a water jet or excessive water when cleaning.
008_012221
A certified electrician must furnish sufficient power for proper machine operation and install any
supplied receptacle (reference unit Data Plate for model specific Volts AC, Hertz, and Wattage
Fasten or Adjust Retaining Ring Latch
1. Open latch then fit retaining ring
over
drum and kettle
rims.
2. Place hook
in
first
slot.
4.
To adjust hook
length
, loosen nut,
adjust hook in or
out, then retighten
nut.
3.
Push clasp tight to kettle
to lock retainer in place.
Corn Treat
Paddle
Kettle
Bottom
Plunger
(plunger must
securely set in
hole in shaft)
Plunger
Knob
Mixing Drum
Retaining Ring
Drum Seal
Drum seal fits
around bottom
lip of drum.
Paddles Shown in Mixing Position
(General image shown for reference.)
