Golander pump WG600S, Руководство по эксплуатации

Страница: 14 / 21

WG600S Industrial Basic Variable-Speed Peristaltic Pump
To set the duration time for each dose
1) Turn on the power switch. The display will be on.
2) Make sure the DIRECTION switch is on middle position.
3) Press SPEED ADJUST dial to change the mode to
Dispense Mode.
4) Press and hold RPIME/DISPENSE key for 3 seconds, the four-digit
LED display will be flashing. Pump is on Time Dispense Setup Mode.
F215
Hold
Flashing
C 2
.
5
Figure 18. Time Dispense Setup Mode
5) When on Time Dispense Setup Mode, use the SPEED ADJUST dial to
set the duration time, the time range is 0.1-999 seconds.
6) Press the PRIME/DISPENSE key again to exit the Time Dispense
Setup Mode.
To Dispense Fluid
1) Press SPEED ADJUST dial to change the mode to Dispense Mode.
2) Change the DIRECTION position for running direction, clockwise or
counterclockwise.
3) Press PRIME/DISPENSE key to run dispensing process. Press
PRIME/DISPENSE key to dispense fluid again.
6.6 Logic Level Control Mode (H)
Use external logic level signal to control start and stop.
1) Switch the power of the pump off. Wire the DB15 connector as shown
on Figure 19 or Figure 20 , and connect it to the DB15 port on the rear
of the pump.
F215
12