Gogen DECKO PREHRAVAC, Руководство по установке

Страница: 38 / 44

EN
2.
Use
M.+
button to choose the desired sequence you want to store, then press the
MEM./PROG
button on unit to enter.
3.
Search another station, repeat steps (1) & (2) until all desired stations stored. Up to 30
stations can be programmed.
4.
Press the
M.+
to listen to the stored station directly.
BLUETOOTH OPERATION
1.
Press the
SOURCE
button to switch to BLUETOOTH function, the LCD will display flashing
“ bt
” at high speed.
2.
Turn on the Bluetooth function on the device, scan the unit “
DECKO PREHRAVAC
” and
connect, then input the password 0000 if required, the “
bt
” will show steadily to indicate
connection done.
3.
Press the button on the unit or play key on the device to start playback.
NOTE: If the unit can‘t connect the relative Bluetooth within 2 minutes, press and hold the
PAIR
button on unit to reconnect.
4.
Press the
VOL.+/-
buttons to select your desired level.
5.
Press the

/TUN-
or

/TUN+
on the unit to choose the desired track.
6.
To interrupt playback, press button.
7.
To disconnect the Bluetooth, press and hold the
PAIR
button.
NOTE: The Bluetooth works best within 10 meters.
USB OPERATION
1.
Press the
SOURCE
button to choose USB mode.
2.
Connect the USB to the USB INPUT. The LCD will show the total number of tracks and
folders stored in the USB. After reading the USB, the unit will start playback automatically.
3.
Press button to pause and resume playback.
4.
Press the button to stop playing. The display will show total number of tracks and folders
and stop.
5.
Proceed repeat play (repeat 1- repeat folder - repeat all) /program play/skip up and back
operation as the same described in above “CD/MP3 OPERATION”.
CAUTION: Do not use any USB extension cable for connecting the USB device to avoid any conflict.
CD/MP3 OPERATION
This system can playback all digital audio CD, MP3, WMA finalized digital audio CD-Recordable
(CD-R) discs, finalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital
audio CD/CD-R/CD-RW discs.
LOADING A DISC
1.
Press the
SOURCE
button on until to select “CD” mode.
2.
Press the PUSH TO OPEN button to open the CD door, “
OP
” will be shown on the display.
3.
Place an audio CD DISC into the tray with the front side facing up.
4.
Close the CD door. The display will show a flashing “
- - -
”, then the total number of
trackswould be shown and the playback will starts fromthe first track.
5.
To remove the CD, press button to turn off the unit,press PUSH TO OPEN button to open
CD door, the display will show “
OP
”. Hold the CD by its edges, and carefully take it out.
NOTE: To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will show „
NO DISC
“.
PLAYING A DISC
1.
The unit will start playback from track 1 after reading finished. The
“

“
indicator and the
current track would be shown on the display.
2.
To interrupt playback, press the button. The
“

“
indicator will flash on the display.
3.
To resume playback, press the button again.
4.
To stop playback, press the button, the total number of tracks appearson the display.