
GOGpaintball.com
The Vision
TM
eye covers of the eXTCy
TM
are easily removed to provide access to both the Vision
TM
sensors and the marker’s ball-detents. To remove the eye covers, first unload
and de-gas the marker following the instructions in this manual, then use a 0.050-inch allen wrench through the eye-cover access hole to unscrew the eye cover retaining screw,
then tilt the eXTCy
TM
to the side, and if necessary tap it lightly against one hand to work the eye cover out.
With the eye cover removed, an o-ring pick can be used to pry the Vision
TM
LED or detector out of its pocket by one of its top corners. Care must be taken not to scratch the
dome shaped lens molded into the body of the eye. With the eye gently folded out of the way, the eye, eye pocket and ball detent opening in the breech may all be thoroughly
cleaned with a cotton swab.
If the ball detent is worn to the point that it does not protrude slightly into the breech, or dirty to the point that it does not spring easily in or out, it may be removed from the eye
cover for cleaning or replacement. To remove the ball detent, use an o-ring pick to carefully pry back the ball detent retaining fingers one at a time and work the detent out of the
eye cover. If the ball detent is excessively worn, it must be replaced for proper operation of the eXTCy
TM
. The ball detent spring may become bent or damaged during removal
of the ball detent. If this happens, it must be replaced. After cleaning or replacement, fit the ball detent spring into the ball detent, set its other end on the spring guide in the eye
cover, then carefully work the detent past the detent retaining fingers. Note the alignment of the ball detent for a proper fit, its wider flat edges should be at the top and bottom.
When re-installing the eye cover, use the long end of the allen wrench to tighten the eye cover retaining screw.
Take care not to cross-thread the eye cover retaining screw, or
tighten it beyond a snug fit, these can cause permanent, non-repairable damage to the breech.
FIG. 11
VISION/DETENT CLEANING
CLEANING
16
FIG. 12
FIG. 13
EYE COVER REMOVAL
EYE CLEANING
BALL DETENT REMOVAL
TM
Содержание eXTCy Series
