GF-P8 MANUAL
2012
1
Virtual Pilot Operating Handbook
GF-P8
8 Pushbutton/LED Panel
Cockpit Control Module
simulation experience more realistic and enjoyable.
Congratulations on your purchase of a
GoFlight
GF-P8
8-Pushbutton/LED
Panel
module, part of the extensive
family of GoFlight GF-P8 Cockpit Control
System modules with a wide variety of
aircraft and is sure to make your flight
The steps below will assist in ensuring the GF-P8 will be easy to install, configure and use. Following
these instructions will help to get you up in the
“virtual skies” as quickly as possible.
NOTE
If you own other GoFlight hardware and have already installed the most current
version of software on your system, you do not need to install the software again.
Simply skip the software installation steps in the instructions below
.
Installing a GF-P8 Module
2. On the GoFlight home page click Support.
3. Click on
“GF Config x.xx” to download the latest module drivers and configuration software.
4. Click
“Run” or “Save” and follow the instruction to install the software. If the software installer detects
that GoFlight software is already installed on your system, it will prompt you to overwrite. Click the
Yes
button to overwrite the existing version of GoFlight software. This is useful if you wish to keep the
configuration settings for other GoFlight modules installed on your system. However, you should first
make sure that the software you are overwriting is an older version and not a newer one.
5. If you are going to mount the GF-P8 module into a GF-AC rack, install the module in any desired
location in the rack using the two thumbscrews provided.
