2
Step 9
Place Lock Washer onto Hex Bolt end;
thread on Lock Nut. Repeat for each
Hex Bolt on each Side Bar as shown.
Step 8
Position Straight Bar as shown in fully
assembled photo. Line up Straight Bar
holes with Side Bar holes; slide Hex Bolt
with Lock Washer through holes as shown.
Step 7
Place Lock Washer onto Eye Bolt end;
thread on Short Capped Nut. Repeat for
each Eye Bolt on each Side Bar.
Step 10
Put Chin Up Station in Push Up Position
on a flat surface to level. Then securely
tighten all Nuts with wrench. Fully
assembled Chin Up Station shown
to the left for reference.
Easy In-Out Installation
Standing on non-hinge side of doorway,
put Leverage Bar through doorway while
moving it upward—position it above
moulding to securely hang on door frame.
Position bottom edge of Leverage Bar into
the installed metal wedge, then guide
Chin Up Station down until it securely
rests on top of door frame/moulding.
Make sure the protective Foam End
Pieces on the non-hinge side of doorway,
are in full contact with and resting against
the two side door frame mouldings.
Fully Assembled
Metal wedge
ELEVATED CHIN UP STATION
For questions or missing parts, please contact GoFit at 888-530-4441
©2012 GOFIT, L.L.C. TULSA, OK
