Goelst G-Motion, Руководство пользователя

Страница: 26 / 44

22
4 Programming
English
2.3.1 Sun light sensitivity
motor LED colour yellow:
To use the Sun sensor, define its sensitivity (see below) AND its behaviour (§ 2.3.3).
Connect the Goelst light sensor to the underside of the motor unit via the RJ45 plug.
Make sure that the sensor is properly placed and oriënted correctly towards the light source.
If light intensity exceeds set intensity for more than 5 mins. uninterrupted the sensor
generates a close signal.
If light intensity stays below set intensitiy for more than 15 mins. uninterrupted the sensor
generates an open signal.
The response to these signals can be defined in § 2.3.3.
If a Sun light induced event is overruled by another controlling signal (manual operation,
time controlled, remote control), the sensors Sun signal will be ignored for 4 hrs.
The Sun sensor signal is effective again after these 4 hrs. or after a power cut.
Note: Dawn/Dusk events are not affected by an overruled Sun sensor event.
After 15s. without input, the motor unit quits programming mode.
Please read the steps of this feature first before starting.
SET Sun light sensitivity
1. Press and hold the
OPEN
+
CLOSE
buttons until the LED on the motor unit slowly flash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
2. Repeatedly press OPEN or CLOSE until the LED on the motor unit is yellow.
3. Shortly press the OPEN + CLOSE buttons to enter the feature menu,
4. The LED on the motor unit now flashes yellow at the current setting:
5. Cycle through the options below using
OPEN
or
CLOSE:
1x flash = Normal sun intensity (Default)
2x flash = Low sun intensity
3x flash = High sun intensity
4x flash = current sun intensity
6. Confirm and store setting by shortly pressing
OPEN
+
CLOSE
buttons.
7. The LED on the motor unit slowly flashes white again for 15 seconds: using the
OPEN or CLOSE buttons another MENU 2 feature can be selected.
8. Otherwise, wait for 15 seconds or shortly press the OPEN + CLOSE buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To quit programming at any time, repeatedly press the OPEN
+
CLOSE buttons or wait for 15s.
Changes made at 5 will only be saved if confirmed by pressing the OPEN
+
CLOSE buttons
.