2
| Deutsch
11
| English
www.goebel-group.com
3. Tool Operation (Important tips before starting work)
Please charge the battery to 100% (according to relevant government regulations)
before first use. Please make sure not to stop charging below 50% of the battery power.
3.1 Preparation and review of specifications
In advance, the specifications of the lockbolt, the borehole and the thickness of the
workpiece should be considered. Due to different types and specifications of lock
-
bolts that can be provided by different suppliers, the installation performance will vary
greatly. Therefore, a pre-installation (trial setting) is required, before the official setting
process. We recommend that you use GOEBEL lockbolts for optimum processing.
3.2 Instructions for the setting process
Dept.
Technical reference
Created by
Approved by
Document type
Document status
Title
DWG No.
Rev.
01.10.21
GO-LB1_Bedieungsanleitung
Elias Goebel
Dept.
Technical reference
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
D
E
F
A
B
C
D
E
F
Dept.
Technical reference
Created by
Approved by
Document type
Document status
Title
DWG No.
Rev.
Date of issue
Sheet
01.10.21
1/1
GO-LB1_Bedieungsanleitung
Elias Goebel
The lockbolt and the lockring are inserted into the intended drill hole of the component
in the direction of the arrow
①
. Note that this is done vertically!
➁
Now that the lockbolt and the lockring are inserted into the workpiece, the setting
tool can be guided to the component (in the direction of the arrow).
➂
The mouthpiece of the GO-LB1 now receives the thread of the lockbolt.
①
➁
➂
