3.
As a Wired Shutter Release
3.1 Connect the receiver and the camera by Remote
Cable (one end in receiver’s Shutter Release
Port, the other end in camera’s shutter port)
before turning on the camera.
3.2 Half press the <TEST> Trigger Button to focus.
When fully press the <TEST> Trigger Button to
shoot, the Status Indicator Lamp will turn red until
releasing the button.
Using the Flash Trigger
4.
As a Wireless Studio Flash Trigger or Speedlite
Trigger with PC Sync Socket
4.1 The connection method of the receiver can be
found in As a Wireless Studio Flash Trigger and As
a Wireless Speedlite Trigger section.
4.2 The transmitter will control the flash on the
receiver end to fire via using PC Sync Socket as
input by default.
4.3 Press the camera shutter and use the PC Sync
Socket’s signal to control the flash.
4.4 PC Sync Socket can also be set as output. Long
press the <CH> Button of the transmitter until
<Fn> is displayed on the panel. Then, set the
value of Fn 03 to 1, and the PC Sync Socket is
under output mode.
- 29 -
Setting the Transmitter
Slide the Power Switch to ON, and the device is on and Status Indicator Lamp will not blink.
Note: In order to avoid power consumption, turn off the transmitter when not in use.
Power Switch
Slide the power switch to ON, and the AF lighting is allowed to output.
Power Switch of AF Assist Beam
Channel Setting
1. Short press the <CH> Button until the
channel amount blinks.
2. Turn the Select Dial to choose the
appropriate channel. Press the <CH> Button
again to confirm the setting.
3. This flash trigger contains 32 channels
which can be changed from 1 to 32. Set the
transmitter and the receiver to the same
channel before usage.
- 30 -
