Flash Mode: TTL Autoflash
This flash has three flash modes: TTL, Manual (M), and Multi
(Stroboscopic). In TTL mode, the camera and the flash will work
together to calculate the correct exposure for the subject and the
background. In this mode, multiple TTL functions are available:
FEC, HSS, second curtain sync, modeling flash, etc.
*
Press <
MODE
> Mode Selection Button and three flash modes will
display on the LCD panel one by one with each pressing.
TTL Mode
Press <
MODE
> Mode Selection Button to enter TTL mode. The
LCD panel will display
<
TTL
>.
●
Press the camera release button halfway to focus. The aperture
and effective flash range will be displayed in the viewfinder.
●
When the shutter button is fully pressed, the flash will fire a pre-
flash that the camera will use to calculate exposure and flash
output the instant before the photo is taken.
FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3rd stops.
It is useful in situations where minor adjusting of the TTL system is
needed based on the environment.
Setting FEC:
Set the flash exposure
2
compensation amount.
●
Turn the Select Dial to set
the amount.
●
“0.3”means 1/3 step,
“0.7”means 2/3 step.
●
To cancel the flash
exposure compensation,
set the amount to “+0”.
Press <
SET
> button again
3
to confirm the setting.
Press Function Button 2
1
<
>. The icon <
>
and flash exposure
compensation amount will be
highlighted on the LCD
panel.
- 35 -
- 36 -
●
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check
the battery level indication on the LCD panel to see the remaining
battery level.
Battery Level Indication
3 grids
2 grids
1 grid
Blank grid
Blinking
To unload the battery, tap the
3
white knob and the battery
pack will pop out. Then close
the compartment.
Attaching to a Camera
Attach the Camera Flash.
1
●
Slip the camera flash’s
mounting foot into the
camera’s hotshoe all the
way.
Secure the Camera Flash.
2
●
Rotate the lock ring on the
mounting foot until it locks
up.
Detach the Camera Flash.
3
●
Rotate the lock ring on the
mounting foot until it is
loosened.
The battery level is going to be used out
immediately. And the flash will auto power off
in 1 minute.
Note: Please recharge the battery as soon as
possible (within 10 days). Then, the battery can be
used or be placed for long period.
Meaning
Full
Middle
Low
Lower battery, please recharge it.
Power Management
Use ON/OFF Power Switch to power the flash unit on or off. Turn off
if it will not be used for an extended period of time. Setting as a
master flash, it will turn the power off automatically after a certain
period (approx. 90 seconds) of idle use. Pressing the camera
shutter halfway or pressing any flash button will wake up the flash
unit. Setting as a slave flash, it will enter sleep mode after a certain
period (adjustable, 60 minutes by default) of idle use. Pressing any
flash button will wake it up.
C.Fn
C.Fn
Disabling Auto Power Off function is recommended
when the flash is used off camera. (C.Fn-
APO
, Page 49)
Slave Auto Power Off Timer is set to 60 minutes by
default. Another option “30 minutes” is available. (C.Fn-
Sv APOT, Page 49)
