- 33 -
- 34 -
AD600 can only be set as slave unit (receiver end). Press Wireless Selection Button to switch the two wireless
modes: radio transmission and optical transmission. When using radio transmission, AD600 will automatically switch
between Canon (C) and Nikon (N) system according to X1 series transmitter. When using optical transmission,
please set AD600 to Canon (C) or Nikon (N) before firing a flash.
Wireless Mode
OFF
Radio Transmission
Optical Transmission
Flash Mode
M / Multi
TTL / M / Multi
TTL / M / Multi
Wireless Flash Mode
Battery
Features
1.
This flash unit uses Li-ion polymer battery which has long runtime. The available charge-and-discharge times are
500.
2.
It is reliably safe. The inner circuit is against overcharge, overdischarge, overcurrent, and short circuit.
3.
Take only 4 hours to fully charge the battery by using the standard battery charger.
Cautions
Do not short circuit.
Do not expose to rain or immerse into water. This battery is not water proof.
Keep out of reach of children.
No over 24 hours' continuous charging.
Store in dry, cool, ventilated places.
Do not put aside or into fire.
Dead batteries should be disposed according to local regulations.
If the battery had ceased using for over 3 months, please make a full recharge.
Loading and Unloading the Battery Pack
Push down the battery pack
2
until it is locked.
Match the battery's groove with
1
the main battery compartment's
ridge.
Push the battery pack upward
2
to unload it.
Push the Battery Locking Ring
1
to the right.
Loading:
Unloading:
Battery
Power Management
Long press the <
ON/OFF
> Power Switch for 2 seconds to control the on/off of the flash unit. Turn off the power
pack if the flash unit will not be used for an extended period (approx. 1 hour).
Disabling Auto Power Off function is recommended when the flash is used off camera. (C.Fn-APO, Page 44)
C.Fn
Battery Level Indication
Attach the battery pack to the flash correctly. Be aware of the battery level by check the battery level indication on
the LCD panel when using.
Note: The two indications are almost the same except of grids shift.
3 grids
2 grids
1 grid
Blank grid
Blinking
1 red grid +3 green grids
1 red grid +2 green grids
1 red grid +1 green grid
1 red grid
Full battery
Medium battery
Low battery
Lower battery, please recharge it.
Battery Level Indication
on the LCD Panel
(Indicating battery level and
management of the whole flash
system)
LED Battery Level Indication on
the Battery
(Indicating battery level and
management of non-loaded battery)
The battery level is going to be used out immediately.
And the flash will auto power off in 1 minute.
Note: Please recharge the battery as soon as possible
(within 10 days). Then, the battery can be used or be
placed for long period.
Meaning
