EZ-6000Plus Rewinder / Stripper Installation Guide
EZ-6000Plus
背紙回收器
/
剝紙器安裝說明
1. Rewinder Installation
背紙回收器安裝
1
Motor Module
馬達模組
2
Rewinder Module
背紙回收模組
3
Rewinder Full Sensor Connector Plate
滿紙偵測器連接插頭遮蓋
4
Paper Clip
背紙回收固定夾
5
Label Rewind Bracket
標籤紙回收導紙架
6
Wire Binder
束線帶
7
Belt
傳送皮帶
8
Screw x 10pcs
螺絲
x 10pcs
1
2
3
4
5
6
7
8
1. Place the printer onto a smooth surface
and open the Top Cover.
將機器置於平面上並掀起上蓋。
2. Unscrew all screws that marked in square
as indicated in figure. Remove Top Cover
and Left Cover of the printer.
移除圖中方框內所有的螺絲，將上蓋及側蓋
一起卸下
【
Note /
注意】
Before the installation, please power off the
printer and unplug the power cord.
安裝背紙回收器裝置時
,
請先將電源開關關閉並
拔除電源線。
3. Remove connectors on both sides of
Power Module.
拔除電源模組兩端的連接線。
4. Unscrew the two screws on bottom of
Power Module and remove the Power
Module.
鬆開電源模組下方兩端的螺絲以移除電源
模組。
5. Remove the connection wire between
main board and Standard Connection
Plate.
移除標準連接插頭遮蓋與主板之間的連接
線。
1
