Goddess FTE 0100 WW8, Инструкция по эксплуатации

Страница: 31 / 36

ENG
ENG - 31
TROUBLESHOOTING
Caution! Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this
manual.
Important! There are some sounds during normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
Appliance dose not work
Mains plug is not plugged in
or is loose
Insert mains plug.
Fuse has blown or is defective Check fuse, replace if
necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freezes too much
Temperature is set too cold
or theappliance runs at MAX
setting.
Turn the temperature
regulator to a warmer
setting temporarily.
The food is not frozen
enough.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting
section.
Door was open for an exten -
ded period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Heavy build-up of frost on
the door seal.
Door seal is not air-tight.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a cool
setting). At the same time
shape the warmed door seal
by hand such that it sits
correctly.
Unusual noises
Appliance is not level. Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend
the component out of the way.
• If the malfunction shows again, contact the Service Center.
• These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.