Goddess DFB 946 MW8, Инструкция по эксплуатации

Страница: 73 / 88

EN
EN - 73
Note: *EN50242 – This programme is the test cycle. The information for comparability test
in accordance with EN 50242, as follows:
-
Capacity: 9 setting
-
Position Upper basket: upper wheels on rails
-
Rinse aid setting: 6
-
The power consumption of off-mode is 0 W left-on mode is 0.4 W
TURNINg ON THE APPLIANCE
Starting a cycle wash
1) Draw out the lower and upper basket, load the dishes and push them back.
It is commended That loading the lower basket first, than the upper one (see the section
entitled „Loading the Dishwasher
2) Pour in the detergent (see the section e`ntitled Salt, Detergent and Rinse Aid ).
3) Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of
the socket is 10 A 250 VAC. Make sure that the water supply is turned on to full pressure.
4) Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
5) Press the program button.
If a program is selected, the response light will light.
Then press the START/PAUSE button, the dishwasher begins to wash.
NOTE:! - When you press the START/PAUSE button to pause during washing, the program light
will stop blinking and the dishwasher will mooing every minute unless you press the START/
PAUSE button to start.
Change the Programme…
PREMISE:
1) You can modified the washing program, just the dishwasher has been running for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must be
refilled (see the section entitled „ Loading the Detergent „ ).
2) Press the button of start/pause to pause ,then press the button of program more than
3 seconds, the machine will be in standby state, then you can change the program
to the desired cycle setting (see the section entitled „Starting a wash cycle ...“).
NOTE:
If you open the door during a wash cycle, the machine will pause. The program light will stop
blinking and the buzzer will mooing every minute unless you close the door. After you close
the door, the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
a) One of the program lights on,you can choose program --> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking slowly --> run
d) Some of the the program lights fast blinking --> error.