Gocycle G2 MotorFork Guide 1.0
© Karbon Kinetics Limited. All Rights Reserved.
16
M
OTOR
G
EARBOX AND
C
ONTROLLER
I
NSTALLATION
7.1. Carefully lower
the Assembled
MotorGearbox and
Controller into the
MotorFork as shown.
Plug in the two
Anderson and one
white connector as it
is lowered.
7.2. Ensure the
Controller is fully
inserted and that the
Controller securing
hole aligns with the
hole in the MotorFork
to allow installation
of the screw (2164).
7.3. Unhook the
Front Hub and line
up the 6 Spring pins
with the Motor
Torque Bungs. The
Clutch will need to be
manually aligned with
the output shaft of
the MotorGearbox.
To do this, slowly
turn the Hub until it
aligns with the
Output shaft and
then tightly press the
Hub and
MotorGearbox
together.
