Goboservice GOLUX 600, Инструкция по эксплуатации

Страница: 5 / 21

GOLUX600
- 5 -
E
N
G
L
IS
H
1. SAFETY INFORMATIONS
Please, read carefully the following safety instructions before do any operations. The product describes in
this instructions manual is a lighting fixture for the projection of a light beam. It is used usually to light,
with an high level of surface brightness, big areas on which to project decorative effects or fascinating
and special logos and images. The projector must be only used for the purpose it was designed and built
for. It is suitable to illuminate indoor and outdoor environments, any other use is not approved by the
manufacturer and for this reason disclaims any liability for damages resulting from improper or incorrect
use. This unit should be disposed of according to your country’s regulations regarding the differentiated
waste collection and disposal..
1. 1. INSTALLATION – Please, pay attention that during installation there is not
any hinders on the place on which the projector has to be installed. For the
particular requests, the projector must be attached with dowels or screws or
other anchorages suitable with the material to be blocked. Make sure that all
parts for fixing the projector are in a good state of repair and check the stability
of the point of anchorage before positioning the projector.
2. MINIMUM DISTANCE OF ILLUMINATED OBJECTS - The projector must be
placed so that the objects hit by the beam of light are at least 5,0 meters from
the lens of projector.
3. MINIMUM DISTANCE FROM FLAMMABLE MATERIALS -The projector must be
placed so that flammable materials areat least 6,0 metersfrom lensesand 1,0
meter from any other surface point of the projector.
4. 4. MAXIMUM ROOM TEMPERATURE - Install the projector in a place where
there is a good air flow. Please, don’t use it in closed or semi-closed
environments because this could cause an increase of temperature with a
reduction of projector life cycle. For a safe functioning of projector the
temperature must not exceed 45°C.
5. PROTECTION AGAINST INDIRECTS CONTACTS – It is mandatory connect the
projector to a main supply system fitted with efficient ground (Class I appliance
to standard EN 60598-1). It is, moreover, recommended to protect the supply
lines of the projectors from indirect contact and/or shorting to ground by using
appropriately sized residual current devices.
6. CONNECTION TO MAIN SUPPLY - Connection to the electricity main must be
carried out by a qualified electrical installer. Check that the main frequency and
voltage correspond to those for which the projector is designed. Evaluate if the
main supply can withstand the absorbedpower of projector and, if it is, verify
the maximum number of devices that it is possible to connect to the electricity
line, in order to avoid overloading.