Go Power! SW150, SW300 Inverter
Owner’s Manual
7
3.4 Rear view GP-SW300:
a) Chassis ground or to vehicle chassis using # 8 AWG wire.
b) Ventilation
ports:
Do not obstruct, allow at least 1 inch for air flow.
c) Battery
terminals:
Connect to 12 V battery or other 12 V power source: [+] is positive and [-] is
negative. A reverse polarity connection will blow the internal fuse and may
damage inverter permanently.
4. Installation
4.1 Where to install
The power inverter should be installed in a location that meets the following
requirements:
Caution
Do not connect this inverter and another AC source (generator or utility power) to the AC
wiring or AC loads at the
same
time. Doing so will destroy the inverter and void the
warranty, regardless whether the inverter is switched on or off. If you are using more than
one AC source for the AC wiring or AC loads, it is highly recommended that you install an
automatic transfer switch (GP-TS), available from Go-Power Electric Inc.
a) Dry - Do not allow water to drip or splash on the inverter.
b) Cool - Ambient air temperature should be between 0°C and 40°C (the cooler the
better).
c) Ventilated - Allow at least two inches of clearance around the inverter for air flow.
Ensure the ventilation openings on the rear and bottom of the unit are not
obstructed.
d) Safe - Do not install the inverter in the same compartment as batteries or in any
compartment capable of igniting flammable liquids such as gasoline.
e) Inverter should be located within 10 feet of the batteries.
b. Ventilation ports
Warning!
Operation of the
inverter without a
proper ground
connection may
result in an
electrical safety
hazard.
c. Battery terminal
a. Chassis ground
