[page 12] | gpelectric.com
PLANNING LOCATIONS
MC4 Connector
Legend
10A
Fuse
Battery Bank
Refrigerator
Vent Cover
or Cable Entry Plate
PWM 10
Solar Charge
Controller
MC4 Red Postive
Extension Cable (25 ft)
"CLICK"
MC4 Black Negative
Extension Cable (25 ft)
80W
Solar Panel
10A
Fuse
Battery Bank
Refrigerator
Vent Cover
or Cable Entry Plate
PWM 10
Solar Charge
Controller
20W
Solar Panel
5A Fuse
(Included in Solar Panel
Harness)
Battery Bank
Refrigerator
Vent Cover
or Cable Entry Plate
10W
Solar Panel
MC4 Red Postive
Extension Cable (25 ft)
MC4 Black Negative
Extension Cable (25 ft)
MC4 Connector
Legend
"CLICK"
3.3 LOCATING THE GP-PWM-10 AMP SOLAR CHARGE CONTROLLER
The GP-PWM-10 solar charge controller is included in the Go Power! ECO 20W and 80W Kits. The GP-PWM-10 provides
the necessary protection for the RV battery system. A condensed version of the installation instructions appear in this manual.
However, please read the full installation manual included with the GP-PWM-10 solar charge controller.
1. Plan where the GP-PWM-10 charge controller will mount, see Figure 3-B.
• The GP-PWM-10 is designed to be mounted vertically in an indoor location inside a weatherproof enclosure.
• Ideally the GP-PWM-10 should be located so it can be easily seen for monitoring system operation.
• The location will need access to the cable ends from the solar panels and the battery compartment.
Note
WARNING: Failure to secure the GP-PWM-10 could cause it to become dislodged while the RV is in transit and
cause severe damage to the unit and/or the RV.
FIGURE 3-B
