4. Bumper cover will need to be trimmed. Measurements and areas to be trimmed are shown below in Diagram 7.
5. Test fit the bumper cover to make sure it fits on the brackets and then tighten the factory bolts while holding the brackets in place.
6. Make sure all of the bolts and plastic rivets are reinstalled on the bumper cover before installing grille guard.
7. Grille Guard must be set on top of brackets for installation. Align holes in guard with holes in brackets and install at this time. Use (1) 1/2” x 1 1/2” Bolt
with (2) 1/2” Flat Washers, (1) 1/2” Lock Washer and (1) 1/2” Hex Nut per hole in grille guard. Center guard on vehicle and tighten all bolts at this time.
Bumper Cover upper area to trim measurements
Bumper Cover lower area to trim measurements
Diagram 7
Diagram 8
2”
Front View of Brackets Installed
Diagram 6
Factory Bolts
Pass. Side
bracket #
38017-6
Driver side
bracket #
38017-5
Bumper
Reinforcement
Thank you for choosing Go Industries’ products. For additional installation
assistance, please call Technical Support (800) 527-4345 or (972) 783-7444
Page 2 of 2 pages 01/15
Enforcement Series
Grille Guard
Installation Instructions
38017 /39017 / 40017
Dodge Charger ‘15
420 N. Grove, Richardson, TX 75081
Tele: (800) 527 - 4345 Fax: (800) 442 - 5263
Web site: www.goindustries.com
E-mail: [email protected]
5”
Drill Weld and
seperate
