background image

Note: Completely read instructions before beginning installation!

1.    Remove  the  contents  from  the  box  and  check  for  missing  pieces  or  damage.    If  parts  are  missing  or  damaged,  contact  the  original  place  of  purchase.                                              

2.  Remove the bumper cover by following the steps listed below:

 

A.  Remove the plastic push clips on top to free the upper section of the bumper cover.

 

B.  Remove the hex bolts from the bottom of the bumper.

 

C.  Remove the push clips on each side that attach the bumper to the inner fender.

                   D.  Remove the hex bolts in the lower front wheel well area.

 

E.  Remove the factory hex bolts on both sides that hold the bumper cover to the fender.  To access and remove the hex nut you will need to  

 

      push aside the inner fender. 

                   F.   Unplug the side marker lamp.

 

G.   With the help of another person slowly pull the bumper cover off and be careful not to damage the cover. 

3.  Once the bumper reinforcement is exposed, remove the (8) factory bolts that hold the bumper reinforcement to the crash canister.  Once the (8) 

factory bolts are removed, drill out the spot welds above and below the bumper reinforcement on each side. Diagram 4,5 & 7. Use a pry bar to separate 

the bumper reinforcement from the crash canister enough to slide the bracket in between the bumper reinforcement and the crash canister as seen 

in Diagrams 3 and 4.  Please note that the plastic air deflector will need to be trimmed for bracket clearance.  Reference Diagrams 4 and 5 for areas to 

trim.  Make sure the bracket is lined up with the (2) holes on the bumper frame and replace the (8) factory bolts as shown in Diagram 6 (Page 2).  The 

mounting holes in the brackets are slotted for up and down for adjustability.  It is recommended for initial fitting to place the brackets in the furthest 

upward position and make adjustments if needed. 

Passenger view of air deflector trimming

Driver view of air deflector trimming

Diagram 4

Diagram 5

Area to trim

Area to trim

Pry apart

Pry apart

Bumper

Reinforcemen

t

Bumper

Reinfor

cemen

t

Parts List:

1 - Police Grille 

Guard 

1 - Driver Bracket 

#38017-5 

1 - Pass. Bracket 

#38017-6

6 - 1/2” x 1 1/2” 

Bolts

6 - 1/2” Hex Nuts

6 - 1/2” Lock 

Washers

12 - 1/2” Flat 

Washers

Diagram 1

Diagram 2

38017

40017

Thank you for choosing Go Industries’ products.   For additional installation 

assistance,  please call Technical Support (800) 527-4345 or (972) 783-7444

Page 1 of 2 pages   01/15

Enforcement Series 

Grille Guard

Installation Instructions

38017 / 39017 / 40017

Dodge Charger  ‘15

420 N. Grove,  Richardson, TX   75081

Tele: (800) 527 - 4345   Fax: (800)  442 - 5263

Web site:   www.goindustries.com

E-mail:   [email protected]

39017

Diagram 3

Drill Weld

Drill Weld

Отзывы: