Doc. No. 0012680 rev. E
Page 14 of 16
Technical Manual for Discover V BTE
Prepare Ampli
fi
er for mounting into Housing
Solder the 3 mic. wires to the PCB.
Gently adjust the wires and make
sure the wires are placed correct
round the screw hole in housing
(see also next page). Add CH-8 on
the solder points
Solder the 2 rec wires to the PCB. Gently adjust the wires and add CH-8
on the solder points, in the notch and on rec case to
fi
x the wires
Fill the area between the nylon insert and the switch-PCB with grease p/n
6879-199. Do not cover the bolts and the areas which will be visible from
outside (indicated with blue color)
Solder the green wire from battery
spring (-) to the PCB. Solder the
switch board “wing” to the battery
spring (+) and apply CH-8 on both
points
Insert bolts p/n 75921693 (see
next picture).Fix the battery springs
into the partition and solder the
green solid wire (p/n 70927136) to
battery spring (-) (yellow arrow).
Apply CH-8 p/n 75925421 on the
solder point
Place partition complete into lower
housing.Add coat p/n 1908-209 on
the lower area of the partition as
indicated with blue color
Bolt
Bolt
sw board “wing” to
bat (+)
green wire from bat (-)
CH-8
notch
Green
solid wire
to (-)