Nesbo a/s
Page 15
User manual
GB
Nesbo
weed brush UK 125
Daily use
The weed brush can operate with two different brush types: The
standard flat steel brush and a wire brush. If you want to switch from
the flat brush to the wire brush, unscrew the M6x60 machine bolt
located at the base of the brush profile and tighten a new M6x40
machine bolt through the other Ø7 hole in the brush profile before
inserting the brush.
At the end of the season, clean the weed brush and remove any
weeds, soil and other debris. To prevent corrosion, lubricate all moving
parts with oil (but not the motor).
The machine should be stored where there is low humidity and it is
sheltered from rain and snow.
Replacing brushes
All 9 brushes are changed in the same way:
• Remove the hairpin from the brush's locking pin. Take care that
washers and springs do not shoot off.
•
Remove the locking pin from the tube profile and pull the brush
down and out of the brush cone.
• Insert a new brush in the brush cone.
• Insert the locking pin through the brush, through the bottom hole
in the brush profile from the slot side, attach the washer and
compression spring and secure these with the hairpin.
• Using the supplied key, tilt/lift the locking pin clear of the slot and
move the brush to the top position in the brush profile.
Содержание NESBO UK 125
Страница 2: ......
Страница 4: ......
Страница 20: ...Copyright Nesbo a s Daniavej 31 DK 9550 Mariager www nesbo dk 05122019 ...