Front View
Top
Leg
Angle Brackets
1/4-3-1/2”
Flange Head Bolt
Nylock Nut
If purchased attach the undermount drawer:
Attach the drawer mounting pan to the
underside of the table by using
(4) #14 x 1" Lags if being mounted to
a wood cored steel top or solid wood top.
If mounting to a steel top with no wood
core use (4) 1/4-20 x 3/4” flange head
bolts into the preinstalled nuts in the
top support bracets installed in step 5.
Attach the drawer to the underside of
the mounting pan by using (4) 1/4-20 x 3/4"
bolts. Remove the drawer from the shell
to access the mounting holes. The 4 bolts
will thread into four pre-installed nuts on
the bottom of the mounting pan.
Drawer Mounting
Pan Holes
Drawer Mounting
Holes
STEP 6 - Dr
aw
er Option
STEP 5
Attach two angled brackets to each leg
of the workbench using (3) 1/4”x3-1/2”
hex head bolts and lock nuts. Bolts will
run through both brackets and holes
located at the top of the leg assemblies.
Set the top on the assembled
base. Center the top both front-
to-back and left-to-right.
Attach the top to the legs using
#14 x 1" Lags.
If front and back braces are
provided attach to the top using
additional #14 x 1" Lags.
WOOD TOPS or WOOD CORED STEEL
1/4-20 x 3/4”
Flange Head Bolt
#14 x 1”
Lag Bolt
#14 x 1”
Lag Bolt
If purchased attach the lower tube foot brace
to the leg assemblies. Bolt the brace in place
using (4) 5/16” X 2 3/4” HEX HEAD BOLTS &
NYLOCK NUTS. The cross tube of the leg
will be pre-drilled for the bolts.
STEP 7 -
F
oot Br
ace Option
5/16-18 x 2-3/4”
Hex Head Bolt
Nylock Nut
