11
Fitting the keyed chuck
The keyed chuck (14) supplied as an accessory can be
fitted to the SDS chuck with the use of the SDS chuck
adaptor (12).
1. The keyed chuck allows bits with a straight shank to be
used with the tool.
2. Grip and pull back the locking sleeve (11) and insert the
SDS chuck adaptor (12) (Fig. U).
3. It may be necessary to turn the SDS chuck adaptor in
order for it to locate properly (Fig. V).
U
V
4. Release the locking sleeve (11) to lock the adaptor in
place (Fig. W).
5. Screw the keyed chuck (14) onto the threaded end of the
SDS chuck adaptor (12) (Fig. X).
W
X
WARNING.
The keyed chuck (14) is only to be
used in the mode of operation.
It must
NOT BE USED
when an SDS mode
is selected
,
or
.
Maintenance
WARNING.
Always ensure that the tool is switched off and
the plug is removed from the power socket before making
any adjustments or maintenance procedures.
Store the tool, instruction manual and accessories in a
secure place. In this way you will always have all the
information and parts ready to hand.
Keep your machine and its cord clean. The outside of the
machine can be cleaned using a damp soft cloth with a mild
detergent if required.
Some maintenance products and solvents may damage the
plastic parts; these include products containing benzene, 25
trichloroethylene, chloride and ammonia.
CAUTION.
Water must never come into contact with the tool.
Excessive sparking generally indicates the presence of dirt
in the motor or abnormal wear on the carbon brushes.
Take special care to keep the ventilation inlets/outlets free
from obstruction; cleaning with a soft brush followed by
a compressed air jet will usually be sufficient to ensure
acceptable internal cleanliness.
Wear eye protection when carrying out cleaning.
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the trigger
switch. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
Re-lubricate all moving parts at regular intervals.
