10
3. Cut the grass by swinging the trimmer from right to
left and proceed slowly keeping the trimmer inclined
forwards at an angle of about 30°. Light cuts are better
than heavy cuts as they allow the cut grass to fall away
from the spool preventing the grass from clogging the
spool.
4. Start cutting nearest the mains power source and work
away from it to make it easier to avoid the extension
cord.
5. High grass should be cut in layers always beginning
from the top. Do not cut damp or wet grass. Do not
overload your trimmer.
6. Avoid wearing the line out quickly by knocking against
hard objects (stones, walls, fences etc.).
7. Watch out for kickbacks in the event of impact with
hard objects.
8. After finishing the cutting operation, keep the head
close to ground level, release the switch and allow
the motor to come to a complete standstill. Place the
trimmer on the ground, switch off and remove the cable
plug from the mains supply.
Note.
Periodically clean out the grass between the spool
and the rim of the guard to prevent the tool
from vibrating.
Using as an edger
Note.
Always unplug the trimmer before carrying out
any maintenance or making any adjustments to the line
trimmer.
1. Press the handle rotating
button (14) and rotate
the shaft 180 degrees, so
it is facing so the handle
is facing the opposite
direction.
2. Release the rotating
button (14), ensuring
that the handle clicks
into position.
3. You can now
use the line
trimmer as
an edger. The
wheel is used
to guide the
line trimmer
along the
ground.
Changing a line spool
Warning.
Ensure the cutting line blade cover is replaced.
Note.
Always unplug the trimmer before carrying out
any maintenance or making any adjustments to the line
trimmer.
1. Turn the line trimmer upside
down.
2. Hold the spool holder firmly
with one hand and with the
other hand squeeze the tabs
on either side of the spool
cover and remove the cover.
3. Remove the empty spool and
clean out the spool cover.
4. Align the cutaway sections in
the spool opposite the eyelets
and thread the two lines of
the or new spool through
the two eyelets in the spool
holder and insert the spool.
1
4
2
Trimming
Edgeing
