cord away from heat, oil and sharp edges.
10. Secure the work piece.
Use clamps or a vice to hold
the work piece. It is safer than using your hand and
frees both hands to operate the tool.
11. Do not overreach.
Keep your footing secure and
balanced at all times.
12. Look after your tools.
Keep tools sharp and clean for
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Inspect
tool cords periodically and, if damaged, have them
repaired by an authorised service facility. Inspect
extension cords periodically and replace them if
damaged. Keep tool handles dry, clean and free from
oil and grease.
13. Disconnect idle tools.
Switch off the power and
disconnect the plug from the power point before
servicing, when changing accessories and when the
tool is not in use.
14. Remove adjusting keys and wrenches.
Check to see
that keys and adjusting wrenches are removed from
the tool before switching on.
15. Avoid unintentional starting.
Always check that the
switch is in the OFF position before plugging in the
tool to the power supply. Do not carry a plugged in
tool with your finger on the switch.
16. Use outdoor rated extension cords.
When a tool is
used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
17. Stay alert.
Watch what you are doing. Use common
sense. Do not operate a power tool when you are
tired.
18. Check for damaged parts.
Before using a tool, check
that there are no damaged parts. If a part is slightly
damaged, carefully determine if it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, proper mounting and any other
conditions that may affect the operation of the tool.
A part that is damaged should be properly repaired or
replaced by an authorised service facility, unless
otherwise indicated in this Instruction Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does
not turn the tool on and off correctly.
19. Guard against electric shock.
Prevent body contact
with grounded objects such as water pipes, radiators,
cookers and refrigerator enclosures.
20. Use only approved parts.
When servicing, use only
identical replacement parts. Use an authorised service
facility to fit replacement parts.
Additional safety rules for jigsaws
Warnings.
Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on
the nameplate of the tool. A power source with a voltage
greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful
to the motor.
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the blade.
•
Ensure that the lighting is adequate.
•
Do not use the saw unless the guards are in place
•
Keep the shoe flat on the work piece.
•
Do not put pressure on the saw, such that it slows the
motor down. Allow the saw blade to cut without
pressure. You will get better results and you will be
taking better care of your tool.
•
Keep the area free of tripping hazards.
•
Do not let anyone under 18 years operate this jigsaw.
•
Only use blades in good condition.
5