12
Using the REDEYE
®
laser line generator
WARNINGS.
Do not stare directly at the laser beam.
Never aim the beam at any person or an object other than
the work piece.
Do not deliberately aim the beam at personnel and ensure
that it is not directed towards the eye of a person for longer
than 0.25s.
Always ensure the laser beam is aimed at a sturdy work
piece without reflective surfaces, i.e. wood or rough coated
surfaces are acceptable. Bright shiny reflective sheet steel
or the like is not suitable for laser use as the reflective
surface could direct the beam back at the operator.
1. Mark the line of cut on the workpiece.
2. To start the saw lift up the
on/off switch (1).
3. Adjust the speed to suit the
workpiece being cut.
4. Switch on the laser beam
using the laser light on/off
switch (2).
5. Line up the laser line with the
line on the workpiece
6. To begin the cut guide the wood
into the moving saw blade.
7. Switch off the laser beam on completion of the cut.
8. Once finished push the on/off switch down to turn off the
saw and unplug the tool from the power point to prevent
unauthorised use.
Maintenance
WARNING.
Always ensure that the tool is switched off and
the plug is removed from the power point before making
and adjustments or maintenance procedures.
An occasional coat of paste wax on the work table will allow
the wood being cut to glide smoothly across the work surface.
Oiling the arm bearings
The saws arm bearings should be lubricated after every
50 hours of use. Ensure plug is removed from the mains
power supply.
1. Turn the saw on its side.
2. Squirt a generous amount of SAE 20 oil around the shaft
end and bronze bearings.
3. Let the oil soak in overnight in this position.
4. Next day repeat the above procedure for the opposite
side of the saw.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.