
Introduction:
Introduction:
Introduction:
Introduction:
If you are looking for an easy an effective way of connecting and
listening to your Apple lightning device you should consider the iL-
GM3.... The iL-GM3 will play
play
play
play and
and
and
and charge
charge
charge
charge any Apple Lightning device
including iPhone 5-X, iPod Touch (5G), iPod Nano (7G), iPad (4G),
iPad Mini (1G), iPad Mini with Retina etc. The iL-GM3 works on the
CD Changer port of select 2000-09 GM Class II Radios to provide the
best possible sound on the car speaker. Keep in mind
Keep in mind
Keep in mind
Keep in mind any
any
any
any factory
factory
factory
factory
option
option
option
option connected to this port
connected to this port
connected to this port
connected to this port (e
(e
(e
(e....gggg. CD Changer, XM
. CD Changer, XM
. CD Changer, XM
. CD Changer, XM etc.) must
etc.) must
etc.) must
etc.) must
be disconnected
be disconnected
be disconnected
be disconnected.
Installation:
Installation:
Installation:
Installation:
1.
Remove Radio from dashboard to gain access to connectors.
(Vehicle specific radio removal instruction are not part of
this guide, but available upon request)
2.
If present, disconnect 12-pin factory plug from Radio (See
Fig. 1 & 2
Fig. 1 & 2
Fig. 1 & 2
Fig. 1 & 2)
Fig. 1
Fig. 1
Fig. 1
Fig. 1
12-pin Plug
Fig. 2
Fig. 2
Fig. 2
Fig. 2
GM Class II Radio connectors
3.
Connect 12-pin plug removed in step 2 to 12-pin (gray)
connector on installation harness (See Fig.
See Fig.
See Fig.
See Fig. 3
33
3))))
If there was no 12-pin plug on radio, go to step 4.
Fig.
Fig.
Fig.
Fig. 3
33
3
Installation harness
4.
Connect 12-pin plug (See. Fig.
. Fig.
. Fig.
. Fig. 3
33
3) from installation harness
to 12-pin connector on Radio vacated in step 2
5.
Connect 22-pin Molex plug from installation harness (See
Fig. 3
Fig. 3
Fig. 3
Fig. 3) to 22-pin connector on Module (See Fig. 4
Fig. 4
Fig. 4
Fig. 4)
Fig. 4
Fig. 4
Fig. 4
Fig. 4
22-pin Molex connector
6.
They are two switch settings for GM:
1. Dip switches 3 & 8
3 & 8
3 & 8
3 & 8 must be set to “ON” (See Fig. 5
Fig. 5
Fig. 5
Fig. 5)
2.
If radio does not recognize adapter, disconnect 22-pin
plug from module and set dip switches 1, 3, & 8 to “ON”.
Reconnect module and re-test.
Warning:
Warning:
Warning:
Warning: Dip switch changes must be performed while
module is disconnected from harness.