9
Fitting and removing the battery pack
To remove the battery pack from the drill firmly press the
battery release tabs (7) at either side of the battery pack,
and slide the battery backward out of the tool.
To install the battery pack, align rails, on the tool with the
tabs on the battery pack and
slide the battery pack on to
the drill. Ensure the battery
pack is sitting straight on the
foot and correctly entering
the runners. The battery
should slide fully on to the
drill foot until the battery
pack “clicks” into position.
Battery charging
1. Connect charger (9) to
power source. The green
light (a), should light up.
This indicates the charger
is ready to begin charging.
2. Position battery pack on
charger, align rails (d),
on battery charger with
(e) on battery pack. Slide
battery forward onto
charger until it clicks into
position.
3. The red light (b), should
begin to glow continuously,
indicating that the battery
pack is receiving a “Fast
Charge”.
4. After approximately one hour, the “Fast Charge” indicator
red light (b) should go out indicating that the battery
pack is fully charged and that the charger is now in a
“Maintenance Charge” mode, this is confirmed by the
light (a) coming back on. The battery pack can be left
on Maintenance Charge” until you are ready to use it.
5. To remove the battery pack from the charger depress
the battery pack release buttons (6) and slide the
battery off.
Warning.
Do not leave batteries charging for longer than
24 hours.
Note.
Depending on room temperature, line voltage, and
existing charge level, initial battery charging may take
longer than one hour.
Note.
Disconnect charger from power source when not
in use.
To obtain the best life for the battery
Never allow the drill to come to a complete stand still
before recharging. The battery should be placed on charge
whenever the battery is noticeably running down or the
drill no longer performs a task it previously performed.
Avoid conducting short charges. Make sure that the battery
is fully charged every time by allowing the charger to
complete its full charging cycle.
Avoid allowing lose items like screws or nails etc to be
stored with battery packs as these or similar items can
short battery packs and cause a fire or explosion.
e
b
a
d