GMC GMT 610, Руководство пользователя

Страница: 5 / 80

G/H Van (GMT 610) 2005
G/H V
AN
(
GMT 610
)
1
P
AGE
BODY BUILDERS INSTRUCTIONS
The Incomplete Vehicle Document (IVD) is supplied with each incomplete vehicle, and provides information that should be used by
intermediate and final stage manufacturers in determining conformity to applicable Federal Motor Vehicle Safety Standards (FMVSS). The
IVD also includes information which must be followed in order to ensure that Environmental Protection Agency (EPA) and California
emissions certification requirements and NHTSA Fuel Regulations are met.
The Body Builders Book contains information that may be used in addition to the IVD for any manufacturer making alterations to a GM
complete/incomplete vehicle. No alteration should be made to the incomplete vehicle which either directly or indirectly results in any
component, assembly or system being in nonconformance with any applicable Federal Motor Vehicle Safety Standard or Emission
Regulation. Intermediate and final stage manufacturers should be familiar with all Federal Motor Vehicle Safety Standards and Emission
Regulations and aware of their specific responsibilities as manufacturers.
For further assistance contact Upfitter Integration at: 1 (800) 875-4742, or go to our Web site at “ http://www.gmupfitter.com .”
Section 0 — General Instructions
Check for proper clearance between body members and chassis components, which may in any way affect the reliability and
performance of the vehicle by developing abrasion and wear points from moving parts or degradation from extreme environment or thermal
exposure or may increase interior noise. Any attachments must consider chassis components for jounce and rebound motion at maximum
GVW.
Check headlamp aim and all vehicle illumination systems for proper operation when the vehicle has been completed. Re-aim headlamps
when necessary. Check for proper operation of windshield washer, wipers and defroster system. In no case should any alterations affect the
function, physical or mechanical properties, environment or vital spatial clearances of the components, assemblies or systems.
Extreme care must be taken when working on vehicles which have been equipped with Powertrain Control Module (PCM), Sensing and
Diagnostic Module (SDM) (Air Bag Control Module) and ABS Control.
Do not mount any components with large magnets, such as stereo speakers, in the area of the driver’s seat due to the Sensing and
Diagnostic Module (SDM).
The Sensing and Diagnostic Module (SDM) located under the driver seat and S. I. R. sensor at the lower radiator support cannot , under any
circumstance, be moved from their present mounting locations.
(Section 0 — continued on next page)