11
Using the rip fence
The rip fence allows you to make parallel cuts in a sheet
of wood, all at the same width.
WARNING.
Always ensure that the saw is switched off
and unplugged from the power supply before making any
adjustments.
1. Adjust the rip fence to the
required width and secure it
in position with the locking
handle.
2. Ensure that the fence rests
against the wood along its
entire length to give a
consistent parallel cut.
Cutting
NOTES.
1. Use only enough pressure to keep the saw cutting.
Do not force the cutting. Allow the blade and the saw
to do the work.
2. When cutting at an angle ensure that the rip fence is
located on the right hand side of the blade.
3. When cutting rod, use a jig or fixture to prevent the
workpiece from turning.
4. When cutting boards vertically, use a push stick to feed
the workpiece into the saw.
Maintenance
Cleaning
1. Always wear eye protection when cleaning this
machine.
2. Keep the tool’s air vents unclogged and clean at all
times
3. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a rag.
4. Re-lubricate all moving parts at regular intervals.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Call GMC on
1300 880 001
We can advise you as to the best method to repair your
tool.
Please do not return the tool to the store where you
purchased it without first contacting GMC.
