INSTALLATION INSTRUCTIONS
SHEET OF
PART NO.
84233234
AUTH
DR
DATE
REVISION
ALL INFORMATION WITHIN
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
SHEET OF
84233234
PART NO.
TITLE
Rear Seat Mudder Cover
REV 15FE17
Rear Seat Mudder Cover
3
3
9
9
6. Re-attach the center seat seatbelt once the cover is on securely.
7. Remove the 40% cover from packaging. Remove the headrest on the 40% seat as instructed in step 1. Slide the cover over
the seat backrest. Align the cutout holes to the headrest post base and tuck-in unfinished edge. Attach Velcro (Hook) on the
backrest of the cover to the seat back. Fold the seat down to adjust. Remove felt strips from Velcro and secure to seat.
8. With the seat partially folded, push the Velcro strip and the two (2) female buckles/straps in between the backrest and cushion.
Use the tabs connected to secure Velcro after removing felt strips to rear seat carpet. Before locking the seat back into the
upright position, ensure that the child seat anchors are aligned and visible.
9. Once the backrest is secured and adjusted into position pull the bottom cushion cover over the front of the seat. Connect the
remaining six (6) “J” hooks on the cover to the corresponding locations on the seat frame. Attached the nylon straps with the
male buckles (2) to the female buckle (2) underneath the seat. Tighten the nylon straps after buckles have all been connected.
10. Re-install headreasts.
Cleaning Instructions:
Gently clean covers thoroughly with mild soap and water.
22AU16 Initial Release - Gino LeDonne
2585499
15FE17
Revision - Gino LeDonne
2618359
