GMC 2008 Chevrolet Express, Пособие по эксплуатации, Страница: 15 / 20

15
To install the rear seats:
1. Position the seat into the open slots in
the floor rails and push the seat for-
ward, hooking the seat onto the rails.
2. Install the locking pins into the seat
base on the inboard sides of the seat
floor latch. Move the seat to line up
with the pins in the seat base.
3. Install the pin marked “R” on the pas-
senger’s side and the pin marked “L”
on the driver’s side.
4. Push the pins down into the retaining
clips. Check that the pins are locked
in place.
5. Connect each shoulder belt by insert-
ing the latch plate into the buckle
attached at each outboard position of
the bench seat.
See Section 1 of your Owner Manual.
Rear-Seat Removal and
Installation (if equipped)
To remove the rear seats:
1. Disconnect each shoulder belt on the
bench seat by pressing the tip of a
key into the release hole of the safety
belt buckle while pulling up on the
safety belt.
2. Locate the two locking pins on the
inboard sides of the seat floor latch.
If there are floormats, the pins are
under a flap cut into the mat. The
driver-side pin has a gray handle
marked with an “L.” The passenger-
side pin has a black handle marked
with an “R.”
3. Pull each pin handle up to disengage
the pins. Pull out the pins.
4. Pull the seat rearward about two inch-
es and lift the seat from the floor rails.
5. Remove the seat.