GM-Racing Punisher Rock Crawler, Инструкция по эксплуатации

Страница: 3 / 28

GUARANTEE CONDITIONS
The guarantee applies only to such material or operational defects which are present at the time of purchase of the
product. Damage due to wear, overloading, incompetent handling or the use of incorrect accessories is not covered by
the guarantee. The user‘s legal rights and claims under guarantee are not affected by this guarantee. Please check the
product carefully for defects before you make a claim or send the item to us, since we are obliged to make a charge for
our cost if the product is found to be free of faults.
Please follow the safety instructions in your own interest. Read these references also carefully if you are already familiar
with the handling and operation of an RC car.
If you discover a part in the kit, which is defective concerning material or processing, send it -
before you used it – back
to us and we will supply replacement to you.
TOOLS REQUIRED
Hex wrench with 1.5 mm, 2 mm (order No. 5775.1,5 and 5775.2), Nut driver 5mm, 5.5mm and 7mm (5783.5,5 and •
5783.7)
Phillips screwdriver PH1, PH2 (5779.1 and 5779.2)
•
small needle-nose pliers •
THE REMOTE CONTROL SYSTEM
Here you get an overview of the remote control system of the Punisher and its various functions and settings. Before the
fi rst trip you should be sure all of these functions and settings have read and understood.
Place 8 AA batteries in the battery compartment of the transmitter. Pay attention to the po-
larity! Now push the antenna wire through the antenna pipe and then put this into the mount
at the chassis (see also page 40).
REQUIRES
To operate your new Punisher you will need the following:
8 alkaline AA batteries e.g. No. 3426, or 12 AA battery cells e.g. No. 3621 for transmitter •
NiMH battery 7.2 V e.g. No. 98900 GM Power-Pack 3600 mAh and a suitable charger like the Graupner Ultramat •
series
Allen key 1.5, 2, 2.5 mm
Wrench 5.5, 7 mm
Needle-nosed pliers
Phillips-
Srewdriver
PH1, PH2
Running multiple vehicle
If you have a vehicle of your and your friends with other vehicles that you will be racing with, it is very important that you
fi rst check what frequency channel your vehicle is on and con fi rm that none of your friends have the same frequency
as yours. If you do fi nd that someone else is using the same frequency channel that you are, you must wait for them to
turn their transmitter and vehicle OFF or you may choose to change the frequency crystals in your transmitter and recei-
ver (so that you can run together at the same time without causing any radio interference). Additional frequency crystal
sets can be purchased separately (order no. 90140.49 - 90140.54, see also frequency table page 42) and installed in a
few quick seconds. To change frequency crystals simply remove the black plastic crystal holder from the back of your
transmitter by carefully pulling it straight out. Slide the crystal out of the holder and install the new crystal labelled „Tx“ in
its place. Then carefully align the two pins that extend from the transmitter, and gently press it into place. DO NOT force
the crystal! The pins can easily be broken! Remove the crystal from your receiver in the same careful manner using a
pair of needle-nose pliers and install the new „Rx“ crystal in its place.
PLEASE NOTE: It is very important that the crystal labelled „Tx“ is installed in the transmitter and the crystal marked
„Rx“ is installed in the receiver.
GM-Racing 90140.RTR PUNISHER Crawler 12