LEDTask™ WP Wet Location Field Cuttable
Flexible LED Tape Installation Guide
for LTR-P-WP and LTR-S-COB-WP Tape
90
C R I
+
DIM
FIELD
C U T TA B L E
65
IP
WET
L O C A T I O N
24
VOLT
2
CLASS
24
TITLE
FIG. 1
®
NOTE: DO NOT INSTALL IN AN APPLICATION THAT IS
OUTSIDE OF THE PRODUCTS LISTED AMBIENT
TEMPERATURE AND IN AN AREA THAT IS NOT EASILY
ACCESSED FOR SERVICE REQUIREMENTS.
1. CUT WP TAPE TO DESIRED LENGTH.
Using
a utility knife or shears, cut tape at cut marks
only. Press blade firmly and apply enough
pressure to cut through silicone sheath that
surrounds tape. Do not exceed maximum run.
Make a clean cut. Return unused tape to pro-
tective pouch that it came in.
(FIG. 1)
2. CONNECTING TAPE TO 24VDC POWER.
Tape comes with pre-connected tape to power
supply leads (48” supplied - trim to needed
length). Use remote LineDRIVE* or compatible
24VDC power supply and connect, using instruc-
tions that come with power supply
(FIG. 2)
.
3. TERMINATING END OF RUN
NOTE: If you are connecting other lengths of WP
tape, go to Step 4. Once you are done con-
necting multiple lengths of tape, terminate end
of run by applying waterproof silicone gel (by
others) around end of tape. Insert end cap and
insure a firm grip. Silicone, properly applied, will
insure a water tight termination.
(FIG. 3).
4. CUTTING AND CONNECTING TAPE BEFORE
USING CONNECTOR
Using a utility knife or
hobby knife, carefully trim approximately 1/8”
of top of silicone shielding that surrounds tape,
leaving tape exposed. Trim carefully so that
base is intact.
(FIG. 4).
5. TAPE TO TAPE OR TAPE TO POWER
CONNECTOR
Flexible tape to tape or tape to
power connectors come in a variety of sizes. To
start, gently pry off the cover of the connector
to expose the terminal block.
(FIG. 5).
BEFORE YOU START:
• Please check local electrical codes before beginning
• Turn power off before installing
• Make sure to use properly rated wire
Trim only on cut marks
Shears or
Utility Knife
Silicone Gel
End Cap
FIG. 2
FIG. 3
Utility Knife
Remove 1/8” off
of Top of
Silicone Jacket
to Expose Tape.
Leave Base Intact.
1/8”
FIG. 4
Utility Knife
Remove 1/8” of
Silicone Jacket
to Expose Tape
FIG. 5
©2022 GM Lighting
Specifications are subject to change
without notice.
18700 Ridgeland Ave.
Tinley Park, IL 60477
Toll-Free: (866) 671-0811
FAX: (708) 478-2640
www.gmlighting.net
LTR-P-WP-FieldCuttableTape_032922
“Lighting Enhanced by Design”
®
DIAGRAM NOTE: TAPE REPRESENTED
IN DIAGRAMS IS LTR-P-WP.
LTR-S-COB-WP CAN BE
USED IN THE SAME WAY.