GLP X4 ATOM series, Инструкция по эксплуатации

Страница: 12 / 28

German Light Products GmbH WWW.GLP.DE
12 X4 Atom User Manual (v.0.1)
4
Connections
Connect the X4 ATOM head only to an X4 ATOM PSU. Connecting
the lighting head to any other device may cause damage.
Never connect any other equipment to the PSU. Doing so may
damage the PSU and/or the device.
4.1 AC Power
Use NEUTRIK® powerCON locking 3
conductor AC connectors to connect the
X4 ATOM PSU to ~90-240 Volt, 50-60 Hz
AC power.
To prevent arcing and potential damage
to the connector, flip the AC power switch
to “O” (off) before connecting or
disconnecting the AC power cable.
The AC connections are color coded. Use a blue powerCON to supply power at the AC
input socket.
The grey AC output socket may be used to supply up to 18 A to additional devices.
Connect a suitable cable to the AC output with a grey powerCon connector. Check the
current draw of the connected devices and do not exceed a total of 18 A.
The maximum
total current load in the AC daisy chain is 20A including the first PSU.
4.2 DMX Data
The X4 ATOM PSU provides 5-pin male and female XLR sockets for USITT DMX-512
Standard data input and throughput.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4 & 5 N.C.
4.3 X4 ATOM heads
Connect X4 ATOM heads to the X4 ATOM PSU with suitable signal and power cables
fitted with 4-pin XLR connectors.
To ensure the IP65 rating of the head, you must
use an IP65 rated XLR female connector such as the NEUTRIK® X-HD Series.
The connections are:
Pin 1 = [Ground] / Pin 2 = [Data +] / Pin 3 = [Data -] / Pin 4 = [V+ 24V]
The maximum cable length is 60 m (200 ft.).
Connect only one (1) GLP X4 ATOM head per PSU output.