GLP Impression FR10 Bar, Руководство пользователя

Страница: 21 / 65

German Light Products®
impression FR10 Bar User Manual Rev. A
21
Load Settings
Using this setting allows the operator to load different customized fixture configurations
and to set the fixture back to the Default Fixture Settings. (To save customized Setting
Presets 1 to 3 see SERVICE

ADVANCED

SAVE SETTINGS)
Note: The Load Fixture Presets and Load Fixture Defaults will only affect settings in the
Fixture Settings and will not affect DMX Address, Control Mode, Protocol Type, IP
Settings, etc. That will help to not losing communication with the controller.
•
Preset 1 ... 3 – Loads one of three specific customized fixture settings. You have to
confirm the function for 3s before the new settings are loaded. For information on
saving fixture settings to a custom preset, see SERVICE

ADVANCED

SAVE
SETTINGS.
•
Default – Loads all the default fixture settings and brings the fixture into standard
show condition. You must confirm the function for 3 seconds before the new
settings will load.
Information
This menu gives fixture information readouts such as a list of any errors that the fixture
has detected, the fixture’s serial number, the currently installed software version,
device info (RDM protocol version, model ID, personality, sub-device, sensor count)
total hours of operation from new, number of power cycles from new, DMX signal
monitoring and signal quality, etc.
Manual Control
This menu gives options to control the fixture manually with no need for a DMX
controller. This can be useful during service or when setting up a stand-alone scene.
•
Reset All – Performs a full fixture reset to initialize all features and effects.
•
Reset Tilt – Performs a reset of the Tilt only in order to re-initialize Tilt position.
•
Reset Head – Performs a reset on all the effects in the head.
•
Manual DMX – Allows control of the fixture using the fixture’s own control panel.
An external DMX signal will always have higher priority than manual control values.
Disconnect the fixture from the control data source when using
manual DMX.
Important! Be prepared for the fixture to start moving without warning when you
enter manual control.
-
Manual DMX – Sends internal values to control each of the fixture’s functions
-
Load No-Signal Scene – Loads the DMX values of the stored captured scene from
the No-Signal feature
-
Save as No -signal scene – Saves the current manual control values as the
captured scene from the No-Signal feature.
-
Capture DMX values – Captures the current external DMX signal values and uses
them as manual control values.
-
Reset Manual values – Resets all manual control values to default.