GLOVIEW 3D TOUCH INTERACTIVE WHITEBOARD MANUAL
16
Tips
1, The range of light Sensitivity should be 5-8. If too high, the mouse will be out of control. If too low, the pen may
not response well with operation.
2, The distance between Calibration Device to the screen (based on 80’’ screen):
Around 2.5-3m (for Model LP1O)
Around 1.2m (for Model SP1O). The whole projection screen should be involved in the red screen. Set
the sensitivity (Please check No 1) according to the environment and make sure there is no any
spot/Green dot in the red screen.
3, Best Installation way: Install the Calibration Device on the ceiling and there is no block between the tip of pen
and receiver. If the Calibration Device cannot be installed on the ceiling, please make sure there is no block
between the tip of pen and the Calibration Device when operation, like user’s body or hand. If there is block,
interrupted lines would happen during writing.
(Remark: if battery is not available, interrupted lines would happen during writing too.)
4, Hold the infrared pen at an angle of 30 – 45° to the projection surface. (No requirement s for Model SP1O)
5, Use Infrared Pen to process the calibration. Place the pen tip at the center of the cross, and then press.
6, Operate right click function: pressure the infrared pen for 2 seconds.
7, USB cable has to be plugged into the port in the back of Computer Box. And extra power may be necessary
when signal device is connected with Laptop,.
8, If the software screen is not red, click “stop” and set another camera in the list of device, then choose “start”
again.
9, If it is failed to open the software, please check hardware key and sometimes you need restart it or try other
port.
10, If the green dot doesn’t move with the operation, please check the frame data of calibration software. When
the frame per second is below 25, it means the computer doesn’t meet the system requirement. A new computer
is needed in this situation.
