Glomex weBBoat 4G, Руководство пользователя и инструкция по установке

Страница: 11 / 24

weBBoat 4G
11
Warning:
- The weBBoat must be fixed to a base/support by tightening the screw
in the base of the weBBoat by means of a screwdriver (
Fig. 6
).
- The installation of the weBBoat near or above a flat metal surface
may result in significant reduction of the Wi-Fi and 3G/4G signal
strength.
- Do not mount the weBBoat near metal obstructions that may inter-
fere with the Wi-Fi signal.
On metal crafts, the Wi-Fi signal is blocked, for this reason it is necessary to
place a second access point (up to a maximum of 4 APs) inside the boat and
connect them with a switch (optional) to the router inside of weBBoat via an
Ethernet cable (optional) (Fig. 9). The access point present inside the
radome can be used for the Wi-Fi coverage outside the boat.
Electric connections
For the proper functioning of weBBoat, simply connect the antenna to a 12/
24 Vdc power supply cable (not provided) according to the following guide-
lines.
Connect the red (positive) and the black wire (negative) coming out from the
base of weBBoat to the battery through a red/black power cable. The con-
nection can be made by soldering or with a clamp. It is advisable to have this
procedure carried out by a technician.
IMPORTANT : The polarity reversal on the power supply will burn the fuse.
The power line (not supplied) which connects the two wires coming out from
the base of weBBoat must have cables with a cross section of 1.5 mm² by a
length up to 10 m, and 2.5 mm² for longer lengths.
WARNING : in the power line, we recommend placing a switch upstream to
avoid electricity consumption when the weBBoat is not used.
GL00187
LAN1 LAN3
Fig. 9