Glomex MARS V9801, Руководство пользователя и инструкция по установке

Страница: 18 / 42

VENUS SATURN MARS RHINE
60
EN
GLI
S
H
www.glomex.it
15. Make sure that the cable core is correctly
inserted in the central hole of the female con-
nector on the antenna.
Manually screw in the ring nut of connector F.
Once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
16. Remove the two safety straps found on the azi-
muth and lifting gears.
S
WARNING
For a correct assembly, respect the installation
direction indicated in
Fig. 11 .
A different installation from the recommended one
could cause an incorrect operation of the antenna
due to the risk of water penetration into the
radome.
Operations to be carried out inside the boat.
1. Determine the correct position for the control
unit:
- it must be positioned near the satellite
receiver, as the provided coaxial cable is
1.5 m long;
- it must be reached by the power supply cable
coming from the power supply;
- it must be reached by the coaxial cable com-
ing from the antenna (10 m long);
- it must be positioned in a dry and ventilated
area (maximum operating temperature
45° C).
2. Determine the correct position for the power
supply:
- it must be close to the control unit;
- it must be reached by the (red - black) cable
coming from the batteries or from the on-
board panel;
- it must be positioned in a dry and ventilated
area (maximum operating temperature
45 °C).
3. Connect the coaxial cable of the antenna (pre-
viously installed) to the ANTENNA IN input on
the control unit and a coaxial cable between the
RECEIVER OUT output on the control unit and
the decoder.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant
female connectors on the control unit.
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually
screwed in, tighten by ¼ turn by means of a 11
mm wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for the
damage suffered by the receiver.
S
WARNING
Antennas V9000, V9100 and V9801 are designed
to operate with a single decoder; therefore, do not
install signal splitters upstream or downstream the
control unit.
Central coaxial
cable conductor
Fig. 15