Glomex DANUBE NEO R500N, Руководство пользователя и инструкция по установке

Страница: 83 / 146

81
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
10. UPDATING THE SATELLITE FREQUENCES USING THE SD CARD
If satellite frequencies and database cannot be
updated via App (paragraph 8.5) the SD Card must
be used to do so.
The SD card must be inserted into the relevant slot
on the control unit side.
The SD card used for updating must be formatted
in FAT32. Then the CFG.BIN file provided must be
copied on the SD card; proceed as follows:
1. Turn off the decoder, the TV set and make sure
that the switch on the control unit is set to OFF.
2. Remove the control unit from the wall-mounting
bracket (see
Fig. 20 ), open the box by loosening
the screws (see Fig. 16 ).
3. OPTIONAL (in case of built-in installation):
remove the wall-mounting plate (see
Fig. 19 ),
loosen the screws and remove the built-in control
unit.
4. Insert the SD card into the relevant slot on the
control unit side, as indicated in (
Fig. 43 ),
respecting the direction (side with manufacturer
label up) and making sure you have completely
inserted it.
5. Turn on the control unit (set B key,
Fig. 24 , to
ON).
6. If the control unit detects the presence of a SD
card with original GLOMEX software, the led turns
orange and automatically starts the software
updating procedure.
7. If the led stays red and the antenna moves, this
means that no original GLOMEX software has
been detected, or that the SD card has not been
inserted completely. Turn off the control unit and
repeat the procedure from step 5.
NOTA: if the control unit is not immediately turned
off, in a few seconds the led will turn orange and
then green, according to the standard satellite
searching procedure; turn off anyway and repeat
the procedure from step 5.
8. If the update is correctly carried out, the led turns
green. Otherwise, the led turns red and it is
necessary to turn off the control unit and to repeat
the procedure from step 5.
9. Turn off the control unit, remove the SD card and
reinstall the rear cover onto the control unit.
10. OPTIONAL (in case of built-in installation):
insert the control unit into the wall,
reinstall the fastening screws and the installation
plate.
S
WARNING
In case of repeated failures in the software update
procedure, please contact the GLOMEX Service
Centre.
NOTA: it is possible to download the necessary
software updating file from the Glomex website
(www.glomexmobile.com) in section “Technical
Support - Download Area”.
Fig. 43