Glomex DANUBE NEO R500N, Руководство пользователя и инструкция по установке

Страница: 63 / 146

61
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
6. ASSEMBLY
S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
Operations to be carried out outside the vehicle.
1. First of all, make sure you have chosen a
correct position to install the antenna (see
section 5: “Installation”).
2. Carefully clean the 4 mounting plates (P) on the
antenna and the vehicle roof with alcohol and
let evaporate before applying the sealant (
Fig.
8 ).
3. Apply some sealant like SIKAFLEX®252 on the
plates ( Fig. 9 ).
4. Place the antenna in the appropriate position
on the vehicle middle line, respecting the
installation direction indicated in
Fig. 10 and
apply a good pressure on the radome sides to
make the plates correctly adhere to the
mounting surface.
Wait for the sealant to solidify (time varies
according to outer temperature).
5. OPTIONAL OPERATION: remove the plates by
unscrewing the 2 nuts securing them to the
lower radome. Drill the lower radome with an
8 mm bit near the punching, put back the plates
and drill near the previously made holes, again
using an 8 mm (
Fig. 11 ) bit.
Fig. 8
P
P
P
P
Fig. 9
Fro
nt o
f th
e b
oat
Mid
dle li
ne
Fig. 10
Output
connector
Fig. 11