Up
to
5
connections
is
supported
by
E1
at
the
same
time.
6.
How
long
does
it
take
to
connect
to
the
internet
once
powered
on?
It
depends
on
the
local
network
condition,
normally
it
will
take
1~2
minutes.
For
the
first
use
in
one
country,
it
may
take
up
to
10
minutes.
7.
What
may
be
the
cause
if
all
the
LEDs
are
off
when
pressing
the
power
button?
It
may
be
caused
by
low
battery,
please
charge
first.
8.
What
should
I
do
if
it
stops
responding?
Press
the
power
button
for
30
seconds.
9.
What
should
I
do
if
the
local
SIM
doesn’t
work?
Manually
input
the
APN
of
the
SIM
card
(login
to
192.168.43.1,
go
to
‘Settings’
‐
>
‘APN
settings’,
manually
input
the
APN
info
of
your
SIM
card
and
Save.)
For
more
info,
please
visit
www.glocalme.com
Warning
Specific Absorption Rate (SAR) information.SAR tests are conducted using standard
operating positions accepted by the FCC with the device transmitting at its highest certified
power level in all tested frequency bands, although the SAR is determined at the highest
certified power level, the actual SAR level of the device while operating can be well below
the maximum value, in general, the closer you are to a wireless base station antenna, the
lower the power output.
Before a new device can be made available for sale to the public, it must be tested and
certified by the FCC that it does not exceed the exposure limit established by the FCC,
Tests for each device are performed in positions and locations as required by the FCC.For
body worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for this product or when used with an
accessory that contains no metal and that positions the device a minimum of 1.0 cm from
the body.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause.
Undesired operation.Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
