ECO Spot 70 User Manual
Copyright © 2010 Globus New Media LLC
Page 1
Thank you for choosing an ECO Spot™ Gobo projector. This unit is
equipped with a fan cooled discharge light bulb, which delivers light
output equivalent to a 350-600W halogen lamp. Please read this
manual before installing or operating this fixture, follow the safety
precautions listed below and observe all warnings.
Package Contents
Projector with power cord
Test Gobo
Spare gobo retaining ring and drive belt
Safety Information
Electrical Safety
ECO Spot™ 70 User Manual
This product is not for household use, it presents risks of severe injury or death due
to fire and burn hazards, electric shock, lamp explosion and falls.
Place your fixture at a suitable place with good air flow.
Keep flammable materials away from the fixture.
Minimum distance to flammable material = 1 ft (0.3m).
Minimum distance to illuminated surface = 3.3 ft (1.0m).
Provide a minimum clearance of 4 in (10cm) around air vents.
Use only genuine spare parts for part replacement.
Do not look directly into the lamp; it can result in eye damage.
Don’t touch the hot surface during operation, use gloves if necessary.
Always unplug the unit from the power mains before any service is done.
Allow 20 minutes to cool down before servicing the unit.
Replace Lamps only with the same type other lamps may cause damage.
Light fixtures should be installed and maintained only by qualified personnel with
experience in lighting equipment and general electrical experience.
Disconnect the fixture from AC power before handling the fixture.
Always ground (earth) the fixture electrically.
Use only a power source that complies with local building and electrical codes and
has both, overload and ground-fault protection.
Do not use the fixture if the power cable or power plug is in any way damaged,
defective or wet, or if they show signs of overheating.
