Globe FS14, Инструкция по эксплуатации

Страница: 9 / 28

Page 9
Installation
INSTALL FLYWHEEL AND OPERATING HANDLE
Note:
In order to transport the slicer, the flywheel
operating handle and the flywheel is packaged
uninstalled.
1. Move the carriage (5) as near to the operator as
possible (Figure 9-1).
2. Remove the taper pin (30) from the flywheel shaft
(31) (Figure 9-2).
3. Use a hammer to tap the taper pin (30) out of
flywheel shaft (31).
4. Install the shim (32) on the flywheel shaft (31).
5. Insert the flywheel (7) so that the flywheel operating
handle fixing hole (x) is positioned above and to the
left of the axis of the taper pin hole (Figure 9-3).
5
4
Figure 9-1
31
32
30
Figure 9-2
31
7
32
30
7
x
6. Use a hammer to insert the taper pin (30) fully into
the hole of the flywheel shaft (31) (Figure 9-4).
Figure 9-3
30
30
7
Figure 9-4