GLOBBER JUNIOR Series, Руководство пользователя

Страница: 4 / 68

4
ENGLISH
Keep the instructions for future reference.
NF-EN-71
Warning! Protective equipment should be worn. Not to be used in traffic.
50 kg max.
Remove the scooter and all the parts from the box. Set out all the parts
and read the assembly instructions prior to use. Keep the packaging until
assembly is complete.
General instructions
This toy must be assembled by a responsible adult. Prior to use, make
sure that the toy has been assembled properly. Remove all the parts
which are not necessary for play before giving the toy to your child. The
toy should be used with caution since skill is required to avoid falls or
collisions causing injury to the user or third parties.
To use with suitable protective equipment, including a helmet, shoes,
elbow, wrist and knee protectors. Teach the child how to use it safely and
responsibly.
Directions:
- The scooter can be dangerous and can cause traffic accidents when
used on public highways. Don’t use on public roads. It is best used
on a flat, clean surface, free of gravel and grease. Avoid bumps and
drainage grates that may cause an accident.
- The scooter does not include any headlights or lights. It is therefore not
suited for use at night or during periods when visibility is limited.
- Always use under adult supervision.
- Do not allow more than one child to ride the scooter at the same time.
- Do not use on wet days, or on wet ground.
Before and after use:
Make sure that all locking mechanisms are securely locked:
- Check the height of the steering system, and make sure the nuts are
tightened and that the handlebars and the front wheel are perpendicular.
- The minimum height of the T-bar has to be locked at the lowest position
by switching the bullet into the lowest slot. (Diagram A).
- Check all of the connection elements: the brake, the steering column’s
quick release system and the wheel axles must be adjusted correctly
and not damaged.
- Also check the tyre wear.
SCOOTER ASSEMBLY (see page 2)
- Insert the T-bar column into the integrated tube at the front of the
scooter deck between the two front wheels. Make sure the two spring
balls on either side of the bottom of the column "click" into place for
scooter mode.
- To release the T-bar or fold/unfold the scooter, step on the deck with
your foot, press the push button on the side of the deck and pull the
T-bar column back at a 30 degree angle.
ADJUST THE HEIGHT:
Height adjustable handlebar which can be adapted to the child’s height.
- 3 Positions :
• Low position: 54 cm
• Middle position: 61 cm
• High position: 68 cm
The bullet shall be in the hole while adjusting the T-bar height.
Make sure that for the lowest position of the T-bar, the bullet is locked into
the lowest slot (see ‘A’ diagram).
Steering:
JUNIOR’s steering responds intuitively to the movement of the
body (Diagram B).
- When the child leans to the right, JUNIOR turns right!
- When the child leans to the left, JUNIOR turns left!
For the youngest children, on flat surfaces and in straight lines, JUNIOR
has a steering blocking system for better balance and to make learning
easier.
- To lock, press the button above (Diagram C).
- To release, press the red button below (Diagram D).
During use:
- Standing on the scooter, one hand on each handle, push with one of
your feet to move forward. Proceed with caution at the start.
- Braking: a brake is located at the rear, when necessary press down on
it to slow down. Press down gradually in order to prevent skidding or
loss of stability.
- Shoes are mandatory and we strongly advise you to wear trousers and
long sleeve shirts to avoid injury if you fall.
- Explain to the child clearly how to lock the scooter before any use.