Page 6
SmartOne C User Manual
Confidential & Proprietary Information
9100-0410-01 R2.4
GETTING STARTED
THE SMARTONE DEVICE
INSTALLING BATTERIES
The SmartOne is powered by, and comes with, four 1.5V Lithium AAA
batteries. The battery compartment is accessible from the bottom of
the device by removing the four Philips head screws. Remove the
water-tight cover and insert the batteries to align with the positive and
negative markers.
NOTE:
When the batteries are removed and replaced the device will
retain its configuration.
CAUTION: Replaceable Batteries: Risk of explosion of battery if
replaced by an incorrect type. Dispose of used batteries according to
the manufacturer’s instructions.
CAUTION: Upon replacing the Battery Compartment Cover, tighten
the screws according to specification (36 inch-ounces); otherwise
the unit may no longer retain its water-tight capability. Ensure the
cover is reinstalled and tightened to specification (36 inch-ounces).
TURNING ON AND OFF
To turn the device ON or OFF, remove the connector cover from the
end of the device. Then slide the switch actuator towards the desired
direction of the ON or OFF markings.
MOUNTING
The SmartOne C is designed to be mounted to an asset using
double-sided adhesive tape and/or the included mounting bracket.
The mounting bracket includes 4 threaded pem nuts and 4 screws
which allow easy attachment to the SmartOne. The bracket also has
four additional through-holes, used for mounting to assets (screws
for asset mounting not included). The included mounting options
allow for various secure mounting methods while providing proper
orientation of the device for reliable communication with Globalstar's
satellite constellation.
NOTE:
The antenna is located under the product’s cover where the
statement
“THIS SIDE TOWARDS SKY DO NOT PAINT”
is seen.
PHILLIPS HEAD SCREWS
MOUNTING BRACKET SCREWS
ON-OFF SWITCH
PHILLIPS HEAD SCREWS
MOUNTING BRACKET SCREWS
