Note: The default PVC connection parameters can meet the needs of the
majority of areas, so user is not required to reset the parameters; if the modification
of relevant parameters is desired, please delete the original default PVC connection
and then create a new connection.
(A MER protocol (1/39) is included in the default
setting, which cannot be deleted or modified.)
Please refer to the following instructions to configure specific application
modes.
4.2 Multi-user Log-on (supported only by Router
version via its router feature)
4.2.1 Dialing Mode (Dynamic IP)
Description: Under this application, PPPOE(RFC2516) or PPPOA
(
RFC2364
)
protocol
must be supported by the center.
4.2.1.1 Parameter Configuration
Please select “Advanced Setting”——> “WAN” on the main page to enter the WAN
setup page as shown below:
1
)
Please select the PVC to be setup and click on “Edit” button to perform the following
configurations: